Please follow these instructions to ensure the correct installation of your new graphics.
 |
|
Step 1
IMPORTANT: Always start with clean (preferably new) Plastics. To clean use Mineral Turpentine followed by soapy warm water. Ensure the plastics are rinsed and thoroughly dried before installation.
Step 2
Cut a 10mm strip off the backing paper on the end of the graphic, line up all bolt holes and stick down. If the bolt holes don't line up pull the graphic off and re-align. You can also tape the edges to steady the graphic in case it slips when installing.
Step 3
Slowly peel off backing paper in 10mm increments rubbing down the graphic with your thumbs, ensuring you remove any air bubbles.
Step 4
If required, you can heat up the graphic slightly with a hair drier to help mould and shape the graphic to the contours of the plastic this also helps to aid the removal of wrinkles and creases. Always be careful when heating as overheating the graphic can cause the material to warp or stretch out of shape.
Step 5
Always trim all edges that overhang or lift if the graphic is not aligned correctly with a hobby or Stanley knife. Overhanging or ill fitting graphics will get dirt underneath them and may cause the graphic to lift.
Step 6
Always allow at least 48 hours for the sticker to bond correctly to the plastic before riding or washing your bike.
|
Warranty: As this is a custom made product especially for your use and can be difficult to install, we can only warrant products with manufactory defects.
PLEASE be careful when installing your new graphics! Contact Us if you need further advice on installation. |
